Quick Builder CLEAR UV/LED base/ gel, 100ml
- Hjem
- Manikur/Pedikyr
- Base, topp og primer
- Baselakk
- Quick Builder CLEAR UV/LED base/ gel, 100ml Quick Builder CLEAR UV/LED base/ gel, 100ml
Quick Builder Clear – clear base/gel with a wide range of uses.
• Base for gel polishes
• BIO gel
• Bottle gel for natural nail extensions and modeling
• For coating, strengthening, and smoothing the natural nail
• For quick and professional nail refills
• Nail prosthetic material
• Does not yellow or crack
• Soak-off formula
Available viscosities:
1. ORIGINAL – medium viscosity
2. QUICK I – light viscosity
3. QUICK II – thick viscosity
Volume: 8 ml (ORIGINAL only), 15 ml, 100 ml
Curing time: LED 30 sec, UV 1 min
Manufacturer
Prominence SIA
Ingredients
Di-HEMA Trimethylhexyl Dicarbamate, HEMA, Isobornyl Methacrylate, Hydroxycyclohexyl Phenyl Ketone, Bis-Trimethylbenzoyl Phenylphosphine Oxide, CI 60725.
Warning
Warnings: harmful if swallowed, absorbed through skin or inhaled; may cause allergic skin reaction; do not spray or heat; causes eye and respiratory irritation; for professional use only; store at or below 26°C, keep away from heat.
Instructions: 1. Sanitize hands with NAI_S Cosmetics Sanitiser. 2. Prepare the nail plate: file the free edge of the nail and shape it with a 180/240 grit wooden file from NAI_S Cosmetics, gently push back the cuticle with a pusher, apply NAI_S Cosmetics cuticle remover and remove all the dead skin from around the nail, lightly buff the nail with 180/240 grit wooden file from NAI_S Cosmetics. 3. Degrease and clean the nail surface with NAI_S Wipe Off Solution 3 in 1. 4. Apply NAI_S Cosmetics Brilliant Bond. 5. Apply a thin layer of the Quick Builder Clear base and cure in an LED lamp for 30 seconds or a UV lamp for 1 minute. 6. If necessary, even out the nail surface with the Quick Builder Clear base and cure in an LED lamp for 30 seconds or a UV lamp for 1 minute. 7. Apply a layer of NAI_S Cosmetics gel polish (e.g., Quick polish, Gel Polish, etc.) and cure in an LED lamp for 30 seconds or a UV lamp for 1 minute. 8. Apply a NAI_S Cosmetics top coat: tack-free Quick top, Resistant top, Velveteen matte top, or one of the special Quick Dot tops. Cure in an LED lamp for 30 seconds or a UV lamp for 1 minute. 9. Apply NAI_S Cosmetics Cuticle Oil (freesia or cherry) and NAI_S Cosmetics Organic Lotion.
0 anmeldelser for Quick Builder CLEAR UV/LED base/ gel, 100ml
Skriv en anmeldelse
Your email address and phone will not be published. Required fields are marked*
